yyw
New Member
Posts: 8 
|
Post by yyw on Apr 3, 2016 15:31:27 GMT
Hi,
Here is my setup.
Raspbian Jessie installed on raspberry pi 3
USB TL-WN722N
So, eth0 connected to the router and assigned ip 192.168.1.100. wlan0 assigned 192.168.1.40, wlan1 assigned 192.168.1.41
I can start AP and MGMT only if the mode is Airmon-ng even though IN is using wlan1.
Ok, let's make it Airmon-ng and the setting as below
IN wlan1, Manual, 10.0.1.1, 255.255.255.0, sniff|inject at0, monitor interface wlan1
OUT eth0, Current, 192.168.1.100
In this case, I can start AP and MGMT but client cannot be assigned IP address. dnsmasq is running as below
dnsmasq 497 1 0 14:40 ? 00:00:00 /usr/sbin/dnsmasq -x /var/run/dnsmasq/dnsmasq.pid -u dnsmasq -r /var/run/dnsmasq/resolv.conf -7 /etc/dnsmasq.d,.dpkg-dist,.dpkg-old,.dpkg-new --local-service --trust-anchor=.,19036,8,2,49AAC11D7B6F6446702E54A1607371607A1A41855200FD2CE1CDDE32F24E8FB5
Thanks...
|
|
|
|
Post by xtr4nge on Apr 3, 2016 16:16:34 GMT
Hi yyw
- remove/comment all WLAN interfaces that you want to use with FruityWiFi from /etc/network/interfaces
- kill dnsmasq (if it is running) before to start FrutiyWiFi [AP] module because FruityWiFi uses its own dnsmasq config files. (remove auto start dnsmasq from defaults)
/etc/init.d/dnsmasq stop
- wlan0 (internal RPi 3) will only work as an AP (I suggest to use wlan0 for management or for simple attacks with a fake AP [mana and karma will not work with this interface])
- don't use MGMT module until you get default setup working. (use AP module only)
- network-manager can give you problems. (stop network-manager if you can't get FruityWiFi working)
/etc/init.d/network-manager stop
regards,
|
|
yyw
New Member
Posts: 8
|
Post by yyw on Apr 4, 2016 2:35:53 GMT
cool... It works in hostapd mode now
|
|
yyw
New Member
Posts: 8
|
Post by yyw on Apr 4, 2016 8:58:25 GMT
While I had tried some modules like dnsspoof. It cannot be enabled and shown "sh: 1: /usr/sbin/dnsspoof: not found"
And I cannot start Karma too. Thanks
|
|
|
|
Post by xtr4nge on Apr 4, 2016 11:57:04 GMT
Hi yyw,
You need to install the dependencies for each module.
Enter (edit/view) the module page, and install the dependencies.
Also, you can install dependencies manually (install.sh) for each module:
cd /usr/share/fruitywifi/www/modules/{module_name}/includes
./intall.sh
for Karma and Mana, you need to install the dependencies, change the mode on Config (to hostapd-karma/hostapd-mana), start the AP, and then enable Karma/Mana
regards,
|
|
yyw
New Member
Posts: 8
|
Post by yyw on Apr 4, 2016 13:31:48 GMT
Hi xtr4nge,
Thanks for your prompt reply. I got it working already.
|
|
|
|
Post by xtr4nge on Apr 4, 2016 13:59:49 GMT
cool  No prob at all regards, |
|
|
|
Post by xmoods on Apr 27, 2016 6:23:15 GMT
I need help!!!
Hello how are we? I've seen you interact with the forum , I need help , I bought a PI 3 raspberry and need to PLS USE module of Karma , lei with wifi card that brings the raspberry pi default does not work, but the problem I have is that no the ap mudulo appears not to do or I'm wrong but I need help setting .
|
|
|
|
Post by xmoods on Apr 27, 2016 6:27:16 GMT
I feel wifi does not work fruity without cabbage Much hay RESPETO material .
BUY raspberry pi 3 By integrating WiFi card handle my intention is to connect by ssh and create false ap UN but does not display when active module n WiFi AP and configured with hostpad and nothing ... I tried
|
|
|
|
Post by xtr4nge on Apr 27, 2016 9:04:26 GMT
Hi xmoods, The problem is not FruityWiFi, the problem is that the internal card on the RPi3 is limited. Karma, Mana and any module requiring monitor mode will not work with the internal card. You need to use and external wireless card such us RT5370 (check the thread about wireless card supported by Hostapd and FruityWiFi) fruitywifi.boards.net/thread/59/suported-wlan-adapterYou can use the internal wireless card to create a normal AP (no Karma, no Mana) but you can still launch many other modules. You can also use the internal wireless card to get Internet access as interface OUT. regards, |
|
errpi
New Member
Posts: 2
|
Post by errpi on Sept 26, 2016 12:30:59 GMT
|
|
ehsan
New Member
Posts: 27
|
Post by ehsan on Sept 27, 2016 14:44:53 GMT
|
|
