FruityWifi Basic Configuration Help required

graytips
New Member

Posts: 2

FruityWifi Basic Configuration Help required Sept 19, 2015 18:40:52 GMT

Quote

Post by graytips on Sept 19, 2015 18:40:52 GMT

Hello

This is basic question.

My Kali box is in VM and connected to a Wireless Router, through which I have interent in Kali.

I have an alpha card.. I have connected this to KALI.

It is AWUS036H recoganized in KALI as wlan0

I wanted to create a open wifi AP and wants the cleints to connect to it.

Then I need to start ssltrip module in FruityWifi and grab the credentials once the host browses to some https enabled site.

I am bit confused with the basic configuration required for my requirement.

Is there any document on the config module of FruityWifi.

Please guide.

Last Edit: Sept 19, 2015 18:41:39 GMT by graytips

xtr4nge
Administrator

Posts: 362

FruityWifi Basic Configuration Help required Sept 19, 2015 19:25:26 GMT

Quote

Post by xtr4nge on Sept 19, 2015 19:25:26 GMT

Hi graytips,
AWUS036H has a Realtek chipset, and Realtek is not supported by Hostapd.

The only mode that you can attempt to use with that wireless card is [AP] Airmon-ng.

Note: Karma and Mana modules will not work with that mode.

go to: Menu->Config and set the mode to Airmon-ng, also setup IN (wlan0) and OUT (eth0)

If you want to use SSLstrip module, first be sure that all the dependencies are installed (download the module, and check the dependencies accessing the SSLstrip module page)

Start the AP (Wireless|AP) and then start SSLstrip.

regards,

Last Edit: Sept 19, 2015 19:26:20 GMT by xtr4nge

@xtr4nge

graytips New Member Posts: 2	FruityWifi Basic Configuration Help required Sept 19, 2015 20:06:49 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by graytips on Sept 19, 2015 20:06:49 GMT Thank you. Pls clarify while setting up IN (wlan0) and OUT (eth0) , should I choose manuel or current

xtr4nge
Administrator

Posts: 362

FruityWifi Basic Configuration Help required Sept 19, 2015 20:23:40 GMT

Quote

Post by xtr4nge on Sept 19, 2015 20:23:40 GMT

- For IN is usually used [Manual] as the values assigned are going to be reflected on the AP setup.
- For OUT is up to you. [Current] will keep your current setup on the selected interface. [Manual] will assign the values to the selected interface.

regards,

Last Edit: Sept 19, 2015 20:24:41 GMT by xtr4nge

@xtr4nge

FruityWifi Basic Configuration Help required

Post by graytips on Sept 19, 2015 18:40:52 GMT

Post by xtr4nge on Sept 19, 2015 19:25:26 GMT

Post by graytips on Sept 19, 2015 20:06:49 GMT

Post by xtr4nge on Sept 19, 2015 20:23:40 GMT